Luma Touch Support Forums
https://forums.luma-touch.com/

Audio waveform fails to draw after record
https://forums.luma-touch.com/viewtopic.php?f=25&t=8934
Page 1 of 1

Author:  headwerkn [ Tue Jun 08, 2021 6:58 am ]
Post subject:  Audio waveform fails to draw after record

Hi all,

Anyone else get an issue where the drawing of the waveform after recording a Voiceover gets interrupted, leaving the clip appearing "blank" after a brief period? Audio still plays, but you can't "see" it, which is kinda annoying when cutting etc.

Restarting LumaFusion redraws the waveforms as they should be. Wondering if it is a memory issue or something to that affect.

I'm using a 2018 iPad Gen 6 with ~30Gb free storage. 4K timeline but only the single video clip with a few titles and audio tracks on occasion. No colour grading or effects.

Cheers, Ben.

Author:  headwerkn [ Tue Jun 08, 2021 7:07 am ]
Post subject:  Re: Audio waveform fails to draw after record

Screen grab for clarity.

Attachments:
IMG_1682.PNG
IMG_1682.PNG [ 789.47 KiB | Viewed 194 times ]

Author:  BarkinMadd [ Tue Jun 08, 2021 12:58 pm ]
Post subject:  Re: Audio waveform fails to draw after record

I believe I have seen that before using 2.4.4 - I was doing quite a lot of voiceover work earlier this year and I ran into this more than once. I don't think I found a workaround other than reloading the project.

Sorry.

Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/