The answer is no but try experimenting with multi select to move clip and transition. The result depends a lot on the particular situation and I’d say the designers have chosen to avoid possible complications with clip lengths etc.
So LumaFusion finally added the basic feature multi-select ... nice.
But I should have totally clarified my post. Transitions that do disappear are never directly touched. Not sure I entirely understand your second point about clip length complications, because mathematically, anytime transitions disappears, it actually shortens the clip length by the same length of the transition. To me unfortunately that’s definitely a clip length complication. Because transitions don’t extend the length of any clip, they only ‘replace’ portions of the clip length, when transitions do disappear, the clip length shortens by the exact length of the transition.
Note: If I purposely remove the transitions, the clip length remains intact.
Transition sudden disappearance shortens clip length
A 60 second original clip with a 7 second transition added results in a 60 second clip. Whenever the 7 second transition disappears, the clip is shortened by the same 7 seconds, resulting in a 53 second clip. A 60 second clip with a 15 second transition would result in a 45 second shortened clip if the transition ever disappears.
Clip length remains intact if I purposely delete transitions
A 30 second clip with a 5 second transitions results in a 30 second total length clip. If I purposely delete the transition, the original clip length of 30 seconds remain intact. On the other hand, if the 5 second transition mysteriously disappears, the original 30 second clip will now become 25 second.
It’s a finicky issue — it happens every now and then but the clip length will always shorten by the transition length if for some mysterious reason the transition disappears. I only know about this because I usually have multi-stacked clips. If I have 4 stacked clips of 30 seconds each, the entire segment is 30 seconds long. With a 5 second transition effect added to stacked clip one
, if the transition disappears, stacked one clip shortens by 5 second resulting in a 25 second clip length while stacked clip 2, 3, 4 remains intact at 30 seconds.
Edit: figured out how to add screenshots: