Luma Touch Support Forums

Select and Move Multiple Clips?
Page 1 of 1

Author:  Diverds [ Thu Jan 30, 2020 8:10 pm ]
Post subject:  Select and Move Multiple Clips?

Is there a way to select multiple clips so you can move them together on the timeline?


Author:  Mark NZL [ Fri Jan 31, 2020 12:13 am ]
Post subject:  Re: Select and Move Multiple Clips?

No unfortunately. This has been requested often though and hopefully will be implemented sometime.
If the clips are pretty much in a finished state you could export everything, reimport that into the project and trim to the bits you need.
Otherwise it’s a case of moving every clip one at a time.

Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited