Luma Touch Support Forums

Reconnect footage
Page 1 of 1

Author:  Corey_M_P [ Sat Jan 13, 2018 8:06 pm ]
Post subject:  Reconnect footage

Greetings, I searched around but could not find an answer to this.

I was editing a project on my iPad Pro. I had to get a new iPad Pro and set up the new machine using my iCloud backup. The project I was working on is still in LumaFusion on the new device but obviously the footage (that is synched over iCloud) was not on the device. I re-downloaded all my footage. IN the LumaFusion project all the edits are in place, just the media is not connected. Is there a way to reconnect the footage and not have to start the project all over again?

I would appreciate any help someone can give.

Author:  androum [ Sun Jan 14, 2018 9:29 am ]
Post subject:  Re: Reconnect footage

Hello Corey_M_P

thanks for you post.

I suspect from the what you wrote that your media was put into the Photos app on the first iPad then it was synced to iCloud.
When you restored the media to Photos on the second iPad, the 'names' of the clips get changed (by Photos not us). This means that our app cannot track the media across two devices if the media is in the Photos app.

The solution to this would be to archive your project from LumaFusion from the first iPad and restore that project using LumaFusion on the second iPad.

Hope this helps


Androu Morgan


Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited